Steinberg WaveLab Elements 7 Manual Página 360

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 428
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 359
346 Audio Plug-ins
Center (50Hz to 20000Hz)
When the Side-Chain button is activated, this sets the center frequency of the filter.
Q-Factor (0.01 to 10000)
When the Side-Chain button is activated, this sets the resonance of the filter.
Monitor button
Allows you to monitor the filtered signal.
Attack (0.1 to 1000ms)
Sets the time it takes for the gate to open after being triggered. If the Live button (see
below) is deactivated, it ensures that the gate will already be open when a signal above
the threshold level is played back. Gate manages this by "looking ahead" in the audio
material, checking for signals loud enough to pass the gate.
Hold (0 to 2000ms)
Determines how long the gate stays open after the signal drops below the threshold
level.
Release (10 to 1000ms or Auto mode)
Sets the amount of time it takes for the gate to close (after the set hold time). If the
Auto button is activated, Gate will find an optimal release setting, depending on the
audio material.
Analysis (0 to 100) (Pure Peak to Pure RMS)
Determines whether the input signal is analyzed according to Peak or RMS values (or
a mixture of both). A value of 0 is pure Peak and 100 pure RMS. RMS mode operates
using the average power of the audio signal as a basis, whereas Peak mode operates
more on peak levels. As a general guideline, RMS mode works better on material with
few transients such as vocals, and Peak mode better for percussive material, with a lot
of transient peaks.
Live button
When this button is activated, the "look ahead" feature of Gate is disengaged. Look
ahead produces more accurate processing, but adds a certain amount of latency as a
trade-off. When Live mode is activated, there is no latency, which might be better for
"live" processing.
Note that the gate can also be controlled from another signal source via the side-chain input.
When the side-chain signal exceeds the threshold, the gate opens.
Related topics
Audio Plug-ins
Master Section
How do I add effects?
Presets
WaveLab 7
Vista de página 359
1 2 ... 355 356 357 358 359 360 361 362 363 364 365 ... 427 428

Comentários a estes Manuais

Sem comentários