Steinberg WaveLab Elements 7 Manual Página 381

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 428
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 380
12.31 Steinberg Studio EQ 367
[Alt]/[Option] Keep the [Alt]/[Option] key pressed and drag the mouse to change the
frequency of the corresponding EQ band.
[Ctrl]/[Command] Keep the [Ctrl]/[Command] key pressed and drag the mouse to change
the gain value of the corresponding EQ band.
The following parameters are available:
Band 1 Gain (-20 to +24dB)
Sets the amount of cut/boost for the low band.
Band 1 Inv button
Inverts the gain value of the filter. Use this button to filter out unwanted noise. While looking
for the frequency to omit, it sometimes helps to boost it in the first place (set the filter to
positive gain). After you have found it, you can use the Inv button to cancel it out.
Band 1 Freq (20 to 2000Hz)
Sets the frequency of the low band.
Band 1 Q-Factor (0.5 to 10)
Controls the width or resonance of the low band.
Band 1 Filter mode
For the low band, you can select between three types of shelving filters, a Peak (band-pass),
and a Cut (lowpass/high-pass) filter. When Cut mode is selected, the Gain parameter is
fixed. -Shelf I adds resonance in the opposite gain direction slightly above the set frequency.
-Shelf II adds resonance in the gain direction at the set frequency. -Shelf III is a combination
of Shelf I and II.
Band 2 Gain (-20 to +24dB)
Sets the amount of cut/boost for the mid 1 band.
Band 2 Inv button
Inverts the gain value of the filter (see the description of the Invert button for Band 1).
Band 2 Freq (20 to 20000Hz)
Sets the center frequency of the mid 1 band.
Band 2 Q-Factor (0.5 to 10)
Sets the width of the mid 1 band: the higher this value, the "narrower" the bandwidth.
Band 3 Gain (-20 to +24dB)
Sets the amount of cut/boost for the mid 2 band.
Band 3 Inv button
Inverts the gain value of the filter (see the description of the Invert button for Band 1).
Band 3 Freq (20 to 20000Hz)
Sets the center frequency of the mid 2 band.
Band 3 Q-Factor (0.5 to 10)
Sets the width of the mid 2 band: the higher this value, the "narrower" the bandwidth.
Band 4 Inv button
Inverts the gain value of the filter (see the description of the Invert button for Band 1).
WaveLab 7
Vista de página 380
1 2 ... 376 377 378 379 380 381 382 383 384 385 386 ... 427 428

Comentários a estes Manuais

Sem comentários