
38 WaveLab Concepts
Error correction markers
These two marker pairs may be placed manually, but their main use is with the Error Detec-
tion and Correction tool - see Error detection and correction. You can access this tool by
choosing Workspace > Specific tool windows > Error Correction.
Error start and end markers - these markers are used to highlight errors
such as clicks. They can also be saved in an Audio File Workspace file by choosing the
corresponding preference in Audio file editing prefences.
Correction start and end markers - these markers are used to highlight
corrections done on regions previously marked as errors. They can also be saved in
an Audio File Workspace file by choosing the corresponding preference in Audio file
editing preferences.
Related topics
Markers
Marker Window
Error detection and correction
4.5 Metering
WaveLab contains a variety of audio meters to help in monitoring and analyzing audio.Meters
can be used to monitor audio during playback, rendering, recording and also to analyze a
specific selection of audio. There are seven different audio meters in WaveLab, each with
its own separate window. The meters are accessed via the Meters menu, the Shared Tool
windows menu, or from the Meters control bar.
Monitor Modes
You can choose the audio source and the mode for displaying information in the meters.
You can access the following monitoring functions from the Meters menu or via the Meters
command bar:
Monitor Playback - the meters display the audio output of the Master Section
after the dithering section, unlike the Master Section's own meter.
Monitor Audio Input - the meters display the audio input you have chosen in the
Audio Streaming Settings. This is useful for monitoring audio while recording.
Monitor File Rendering - the meters display what is being written to disk during
file rendering, taking into account Master Section settings, with average, minimum and
maximum peak values computed. After rendering, the meter(s) freeze, and remain frozen
until you refresh or change the monitor mode.
Monitor Edit cursor position - the meters display static information about the
audio beneath the edit cursor. Note that the Master Section settings are not taken into
account in this mode.
WaveLab 7
Comentários a estes Manuais